Design
Code | Completion | Credits | Range | Language |
---|---|---|---|---|
2131027 | Z,ZK | 3 | 2P+1C+0L | Czech |
- Course guarantor:
- Lecturer:
- Tutor:
- Supervisor:
- Department of Designing and Machine Components
- Synopsis:
-
1.Introduction to dimensioning of components, properties of materials, designing
2.Machine operation, degradation (breakdowns, wear), diagnostics
3.Connections classification, threaded joints
4.Demountable joints (keys, wedges, pins, rings), pressed and riveted joints
5.Undemountable joints (welded, soldered and glued joints, springs, exercises - checking calclations of components)
6.Pipe technology (distribution, materials and connections, closures)
7.Engines, clutches and brakes
8.Sliding and rolling bearings, operation and inspection
9.Indirect transmissions (belts, chains and ropes). Friction gears
10.Gears. Variators (friction and chain)
11.Mechanisms (four-joint, crank, knee, sets, with intermittent movement, cam)
12.Hydrostatic mechanisms (sources, motors, controls, accessories)
13.Hydrodynamic mechanisms (couplings and converters), system dynamics
- Requirements:
-
Credit assignments for individual exercises, written and oral exam.
- Syllabus of lectures:
-
1.Introduction to dimensioning of components, properties of materials, designing
2.Machine operation, degradation (breakdowns, wear), diagnostics
3.Connections classification, threaded joints
4.Demountable joints (keys, wedges, pins, rings), pressed and riveted joints
5.Undemountable joints (welded, soldered and glued joints, springs, exercises - checking calclations of components)
6.Pipe technology (distribution, materials and connections, closures)
7.Engines, clutches and brakes
8.Sliding and rolling bearings, operation and inspection
9.Indirect transmissions (belts, chains and ropes). Friction gears
10.Gears. Variators (friction and chain)
11.Mechanisms (four-joint, crank, knee, sets, with intermittent movement, cam)
12.Hydrostatic mechanisms (sources, motors, controls, accessories)
13.Hydrodynamic mechanisms (couplings and converters), system dynamics
- Syllabus of tutorials:
-
Exercises are focused on checking of machine components.
- Study Objective:
-
The aim is to master the methods of components dimensioning taking into account the properties of materials and to master general designing processes.
- Study materials:
-
Shigley's Mechanical Engineering Design from 2010 and younger.
Prezentace pro přednášky a cvičení + podklady pro studenty (dostupné na Moodle)
Švec, V.: Části a mechanismy strojů - Spoje a spojovací součásti. ČVUT, Praha, 2002
Švec, V.: Části a mechanismy strojů - Mechanické převody. ČVUT, Praha, 2003
Švec, V.: Části a mechanismy strojů - Příklady. ČVUT, Praha, 2003
Bolek, A.; Kochman, J.: Technický průvodce 6. Části strojů. 1. a 2. svazek. SNTL Praha, 1989 a 1990
Shigley's Mechanical Engineering Design from 2010 and younger
- Note:
- Further information:
- No time-table has been prepared for this course
- The course is a part of the following study plans:
-
- Scénické technologie (compulsory course in the program)