Construction of Electronic Circuits

Relations:

In order to register for the course B0B13KEO, the student must have registered for the required number of courses in the group BEZBM no later than in the same semester.

Course guarantor:

Václav Papež

Lecturer:

Michal Brejcha, Václav Papež

Tutor:

Michal Brejcha, Václav Papež

Supervisor:

Department of Electrotechnology

Synopsis:

Printed circuit boards and modular constructions. Single sided, double sided and multi-layer boards. Through-hole and surface mount technologies. Designing printed circuits patterns. Passive and semiconductor components for electronic circuits. Manual and automated assembly. Soldering techniques. Testing of printed circuit boards during the manufacturing.

Requirements:

The credit reguirements: seminar presentation, realization of electronic circuit, protokol of circuit realization and the student must obtain minimally 50 % of avaliable points in the tests.

Syllabus of lectures:

1. Realization methods of electronic circuits

2. Design technique of real circuits

3. Printed circuits board technologies and component bonding

4. Practical design of printed circuits boards

5. Computer design

6. Passive components - specific properties

7. active components - specific properties

8. Power supplies for electronic circuits, design, realization

9. Component assembly. Soldering technique

10. Switching and wiring components

11. Putting into operation, testing

12. Selection of measuring methods and apparatus

13. Design effect on equipment reliability

14. Basic Standards for electronic equipments

Syllabus of tutorials:

1. Introduction. Safety provisions. Catalogue of components

2. Methods of realization electronic circuits

3. Printed circuits boards design

4. Computer - aided program Kicad

5. Computer - aided program Kicad

6. Electronic circuits realization - scheme

7. Electronic circuits realization - function verification

8. Electronic circuits realization - printed circuits boards

9. Component assembly

10. Electronic circuits realization - soldering

11. Circuits function testing

12. Circuits parameters measuring

13. Final report

14. A credit

Study Objective:

A student are well-educated of properties of fundamental electronic devices, theit application at realization of electronic circuits, technology of ralization of PCB and methods of actuating of electronic equipment

Study materials:

[1] Leonida, G., Handbook of Printed Circuit Design, Manufacture Components & Assembly. Electrochemical Publications, IOM, 2000

Note:

Further information:

https://moodle.fel.cvut.cz/courses/B0B13KEO

Time-table for winter semester 2024/2025:

	06:00–08:0008:00–10:0010:00–12:0012:00–14:0014:00–16:0016:00–18:0018:00–20:0020:00–22:0022:00–24:00
Mon
Tue	roomT2:E1-2 Papež V. Brejcha M. 14:30–16:00 (lecture parallel1) Dejvice haly roomT2:E1-2 Brejcha M. Papež V. 16:15–17:45 (lecture parallel1) Dejvice haly roomT2:E1-2 Brejcha M. Papež V. 18:00–19:30 (lecture parallel1) Dejvice haly roomT2:C4-264 Papež V. Brejcha M. 14:30–16:00 (lecture parallel1) Dejvice roomT2:C4-264 Brejcha M. Papež V. 16:15–17:45 (lecture parallel1) Dejvice roomT2:C4-264 Brejcha M. Papež V. 18:00–19:30 (lecture parallel1) Dejvice
Wed
Thu
Fri

Time-table for summer semester 2024/2025:

Time-table is not available yet

The course is a part of the following study plans: