Tooling for Metal Forming Processes

Course guarantor:

Lecturer:

Tutor:

Supervisor:

Department of Manufacturing Technology

Synopsis:

Basic data and requirements of tooling design in the case of metal forming techniques

Requirements:

Finished bachelor graduation from a Technical University.

Syllabus of lectures:

1. Basic methods of sheet metal forming. 2. The influence of production parameters on the tooling design. 3. Shearing tools. Bending tools. 4. Drawing tools. 5. Requirements for the design of progressive tools. 6. Standardization and normalization in tooling design. 7. Basic methods of bulk metal forming. 8. The influence of production parameters on the tooling design. 9.Tools for open-die forging. 10. Tools for closed-die forging, punching and trimming. 11. Tools for extrusion. 12. Choice of tool material for sheet and bulk metal forming processes. 13. Safety requirements in the die design for sheet and bulk metal forming processes.

Syllabus of tutorials:

Proposal of tooling design for given die stamping and for given closed die forging. Input of production requirements. Analysis of forming parameters. Draft of tooling assembly. Drawing of the given die. Evaluation of the tooling design.

Study Objective:

Gain basic knowledge in tooling design for metal forming processes.

Study materials:

Kotouč a kol.: Tvářecí nástroje, ČVUT 1993; Hellwig,W.: Spanlose Fertigung: Stanzen, Vieweg 2006, ISBN-10 3-528-74042-6; Brjuchanov-Rebelskij: Zápustkové kování I. - III. Praha SNTL 1952 - 1955.

Note:

Further information:

stránky ústavu 12 133 výpis předmětů

No time-table has been prepared for this course

The course is a part of the following study plans: