Logo ČVUT
CZECH TECHNICAL UNIVERSITY IN PRAGUE
STUDY PLANS
2024/2025

Heat and Mass Transfer

The course is not on the list Without time-table
Code Completion Credits Range Language
W16T001 ZK 5P+1C Czech
Garant předmětu:
Lecturer:
Tutor:
Supervisor:
Department of Environmental Engineering
Synopsis:

Garant: Prof. Ing. Jiří Bašta, Ph.D.

Application of momentum, heat and mass transfer to environmental engineering. Tools to solution of tasks connected with fluid flow (mainly air and water), heat transfer and water evaporation and steam condensation.

Requirements:
Syllabus of lectures:

Building heating and cooling load calculation: 1D, 2D and 3D heat conduction, boundary conditions, kvazistationary cases, outside and inside climatic conditions. Thermophysical properties of building materials. Vapour diffusion in walls, its influence on heat transfer. Sun and earth radiation. Building insolation, cooling loads from insolation, combination of radiation and convection loads, room temperatures without air conditioning. Heat exchangers: finned tubes, thermal and hydraulic solution of common heat exchanger, influence of changed conditions, water condensation on coolers. Regenerative and sprayed heat exchangers.

Syllabus of tutorials:
Study Objective:
Study materials:

Hemzal K.: Přenosové jevy v technice prostředí. Praha: Vydavatelství ČVUT, 2007. ISBN 975-80-01-02924-7 (in Czech)

Note:
Further information:
No time-table has been prepared for this course
The course is a part of the following study plans:
Data valid to 2024-05-24
Aktualizace výše uvedených informací naleznete na adrese https://bilakniha.cvut.cz/en/predmet8802.html