Logo ČVUT
CZECH TECHNICAL UNIVERSITY IN PRAGUE
STUDY PLANS
2025/2026

Advanced foundry Technologies

The course is not on the list Without time-table
Code Completion Credits Range Language
2332013 KZ 4 2P+1C+0L Czech
Course guarantor:
Aleš Herman
Lecturer:
Aleš Herman
Tutor:
Aleš Herman
Supervisor:
Department of Manufacturing Technology
Synopsis:

The course is aimed at deepening the knowledge from the basic study of foundry technology. It focuses mainly on the following topics: additive technologies in foundry technology, melting of special castings and the influence of factors on the structure and their properties, electroslag and vacuum remelting of steels, metallurgy of special alloys of non-ferrous metals.

Requirements:

Graduation 2331091 Theory of casting

Attendance at tutorials (any non-attendance must be duly excused and documented by appropriate confirmation).

100% participation in field trips. Presentation of the assigned topic of approximately 10 min.

Syllabus of lectures:

Outline of lectures

1. Introduction to new technologies

2.Technological equipment of foundries

3.Additive technologies in the production of model equipment and moulds and cores, mould machining

4.Methods of melt quality control, effect of melt quality on casting defects, metallurgy of special castings

5.Special metallurgy of steels - electroslag and vacuum remelting

6.Metallurgy of special aluminium alloys

7.Metallurgy of other non-ferrous alloys (Mg, Co, Ni)

8. Forming compounds, binders and their testing

9.Technology of casting on a meltable model

10.Die casting and centrifugal casting

11. Simulation of foundry processes

12.Casting of plastics

13. Excursions

Syllabus of tutorials:

The basis of the exercise

1. Introduction, organizational issues, assignment of presentation topics

2.Smelting - metallurgical processing of cast iron, including thermal analysis

3.Melt - metallurgical processing of Al alloys, including thermal analysis

4.Metallographic and spectrographic evaluation of melts

5.Casting simulation

6. Excursion (OETINGER CZ, Velvary - production of secondary ingots for foundries)

7.Presentations, credits

Study Objective:

Deepening of knowledge in casting technology with emphasis on new technological and metallurgical methods and procedures. Including modern methods of production and production preparation

Study materials:

Presentations on moodle, foreign journals, internet resources in presentations

Note:
Further information:
No time-table has been prepared for this course
The course is a part of the following study plans:
Data valid to 2025-05-06
For updated information see http://bilakniha.cvut.cz/en/predmet8313306.html