Instrumentation Production Techniques

Course guarantor:

Lecturer:

Tutor:

Supervisor:

Department of Instrumentation and Control Engineering

Synopsis:

The aim of the lectures is to extend the engineering knowledge about special production techniques used in instruments design and its functional parts.

Requirements:

Syllabus of lectures:

Theory and praxis of the special parts production techniques (small lathes, Swiss type lathe, precise drilling, fine pressing and punching).

Bearing and balls production.

Production of the flat surfaces, spheres, and cylinder surfaces.

Diamond techniques. Production of lenses, prisms, and optical fibers.

Elastic elements production techniques (springs, membranes, bellows ).

Physical machining technique.

Production of artificial crystals.

Micromachining techniques, Production of composites, 3D techniques.

Syllabus of tutorials:

Study Objective:

Study materials:

Jens Bliedtner, Gunter Grafe, Rupert Hector, Optical Technology, McGraw-Hill Education, 2011.

Carl Sommer, Non-traditional Machining Handbook, Advance Publishing, 2000.

Gatzen, Saile, Leuthold, Micro and Nano Fabrication, Springer, 2015.

Yan, Jiwang, Micro and Nano Fabrication Technology, Springer, 2018.

Note:

Further information:

No time-table has been prepared for this course

The course is a part of the following study plans: