Logo ČVUT
CZECH TECHNICAL UNIVERSITY IN PRAGUE
STUDY PLANS
2024/2025

Engineering Design II.

The course is not on the list Without time-table
Code Completion Credits Range Language
2131023 Z,ZK 5 2P+3C Czech
Garant předmětu:
Lecturer:
Tutor:
Supervisor:
Department of Designing and Machine Components
Synopsis:

Principles of ISO GPS (Geometrical Products Specification). Students will get critical knowledge about ISO system of limits and fits, tolerancing, surface texture, geometrical tolerance, dimensional loops, tolerancing of angles and cones, tolerancing of threads. Integral part of course is a project where students apply and practice their knowledge from lectures.

Requirements:

Assessment from Engeneering Design I, basic skills of CAD (Inventor)

Syllabus of lectures:

- Tolerancnig of linear dimensions

- Tolerancnig of surface texture

- Tolerancing of form, orientation, location and run-out

- Dimensionals chains

- Dimensioning and tolerancing of threads

- Dimensioning and tolerancing of cones

- Preferred numbers

Syllabus of tutorials:

- Representation and dimensioning of gears

- Junction of hub and shaft

Study Objective:

Basic principles for subjects:

- Engineering Design III

- Engineering Design IV

- Machine Parts and Mechanisms I

- Machine Parts and Mechanisms II

Study materials:

[1] POSPÍCHAL, J.: Technické kreslení. Praha, Vydavatelství ČVUT 2008 (2014).

[2] SLANEC, K.: Konstruování. Geometrická přesnost - 1., 2., 3. díl. Praha, Vydavatelství ČVUT.

[3] SLANEC, K.: Základy konstruování. Geometrická přesnost-příklady. Praha, Vydavatelství ČVUT 2001.

[4] Strojnické tabulky

[5] KŘIVÝ, J. , POSPÍCHAL, J. : Fundamentals of Design I. - Technical Drawings. Vydavatelství ČVUT 2005

Note:
Further information:
https://moodle-vyuka.cvut.cz/link/course.php?cx=2131002
No time-table has been prepared for this course
The course is a part of the following study plans:
Data valid to 2024-06-16
Aktualizace výše uvedených informací naleznete na adrese https://bilakniha.cvut.cz/en/predmet5269706.html