Safety in Electrical Engineering 3

Vztahy:

The requirement for course BE0M17BP3 can be fulfilled by substitution with the course BEEZM.

It is not possible to register for the course BE0M17BP3 if the student is concurrently registered for or has previously completed the course BEEZM (mutually exclusive courses).

Garant předmětu:

Lecturer:

Tutor:

Supervisor:

Department of Electromagnetic Field

Synopsis:

The purpose of the course is to give the students basic knowledge of electrical equipment and installation as to avoid danger arising from operation of it, safety work with electrical equipment, basics of the first aid at injury by electric current. Students receive qualification that enables them to work on electrical equipment which is necessary for their work in the Faculty of Electrical Engineering, Czech Technical University (Dean's order No. 1/2007).

Requirements:

Conditions of assessment: 100% attendance on seminars, passing the test.

Syllabus of lectures:

1.Repeated Health and Occupation Safety training is performed according to "Basic Training Guidelines for Health and Occupational Safety for employees and students FEE, CTU in Prague.

2.Qualification of persons, risks and sources of injuries, safety symbols and identification. Guidelines of the safety behavior and work with electrical equipment, first aid at injury by electric current. Electromagnetic compatibility.

3.Safety of electrical equipment. Safety of the work with sources of high voltage. First aid at injury by electric current.

Syllabus of tutorials:

1.Qualification of persons, risks and sources of injuries, safety symbols and identification.

2.Safety in laboratories of the FEE, CTU in Prague, practical instruction. First aid.

3.Written test, assessment, recording of the training.

Study Objective:

Receiving of qualification that enables to work on electrical equipment which is necessary for work in the Faculty of Electrical Engineering, Czech Technical University (Dean's order No. 1/2007).

Study materials:

V. Kůla, M. Kříž: Introduction to Electrical Engineering, FEE, CTU, 1999.

Note:

Further information:

Course may be repeated

No time-table has been prepared for this course

The course is a part of the following study plans: