Structural Mechanics R1

Vztahy:

The course 132SMR2 can be graded only after the course 132SMR1 has been successfully completed.

In order to register for course 132SMR2, the student must have registered for course 132SMR2 in a previous semester or in the same semester.

Garant předmětu:

Pavel Padevět

Lecturer:

Pavel Tesárek

Tutor:

Pavel Tesárek

Supervisor:

Department of Mechanics

Synopsis:

1. Newton's laws, balance of forces, moments, reactions of a mass point.

2. Connections of rigid plates and material points. Calculation of rigid plate reactions.

3. Continuous loading, calculation of reactions and connections on complex systems.

4. Calculation of reactions on lattice structures. Internal forces of lattice structures, method of contact points and intersection method.

5. Internal forces on straight beams.

6. Internal forces on bent and inclined beams.

7. Reaction to the spatial cantilever and calculation of the internal forces of the spatial cantilever.

8. Internal forces on planar composite systems.

9. Calculations of the position of the center of gravity on planar figures. Moments of inertia and ellipse of inertia.

10. Stress analysis of a section loaded with normal force and moment.

Requirements:

There are no requirements for the subject to be connected to other courses.

Syllabus of lectures:

1. Introduction, basic terms, bundle of forces, statics of a material point.

2. System of forces, bundle of forces.

3. Calculation of reactions of rigid plate and spatial cantilever. Continuous load.

4. Reaction of complex systems.

5. Lattice structures. Methods of calculating internal forces.

6. Internal forces on the member, spatial bracket. Schwedler's theorem.

7. Internal forces on bent and inclined beams.

8. Internal forces on planar composite systems.

9. Plane geometric shapes I. Center of gravity and moments of inertia.

10. Plane geometric shapes II. Elispa of Inertia.

11. Stress analysis for a section stressed by normal force and moment.

Syllabus of tutorials:

1. Decomposition of forces in a plane, moments, reactions of a mass point.

2. Calculation of rigid plate reactions. Reaction to spatial consoles.

3. Reaction of complex systems.

4. Lattice structures.

5. Internal forces on straight beams.

6. Internal forces on bent beams.

7. Internal forces on inclined beams.

8. Internal forces on the spatial cantilever.

9. Internal forces on coupled systems.

10. Plane geometric shapes. Center of gravity and moments of inertia.

11. Plane geometric shapes. Ellipse of inertia.

Study Objective:

The aim of the course is to acquaint students with the basic principles of mechanics when calculating the stresses of statically determined building structures.

Study materials:

Avaible on the page of course SMR 1.

Note:

Further information:

https://mech.fsv.cvut.cz/student/ Nutno zvolit odkaz na předmět "SMR1".

Time-table for winter semester 2024/2025:

Time-table is not available yet

Time-table for summer semester 2024/2025:

Time-table is not available yet

The course is a part of the following study plans:

• Stavitelství (compulsory course)