Modeling and simulation I.
| Code | Completion | Credits | Range | Language |
|---|---|---|---|---|
| 2351110 | Z,ZK | 5 | 2P+2C | Czech |
- Garant předmětu:
- Lecturer:
- Tutor:
- Supervisor:
- Department of Production Machines and Equipment
- Synopsis:
-
The subject is focused on explanation of the design of machine tool axis by individual parts and components.
- Requirements:
-
Requirements:
Active participation in seminars
Max. 1 absence (others must be replaced)
Elaborate semestral work
Format - Microsoft World
Range - minimum 10 pages A4
Submission - electronically or printed
3D model in SolidEdge ST9
Exam:
Required credit from seminars
5 questions discussed in the subject
Preparing on paper
Oral examination
- Syllabus of lectures:
-
Design of machine parts
Choice of the material
Tolerance and placement
Bolted joint
Welded and glued joints
Axis and shafts (spindles)
Rolling bearings
Linear management
Measuring
End stops
Energetic chains
- Syllabus of tutorials:
-
Modeling of load-bearing components, production feasibility.
Design and modeling of linear guides.
Design and modeling of measuring, placing machines on the basis.
Design and modeling of end stops.
Design and modeling of axis drives.
Design and modeling of energetic chains.
Modeling of general assembly.
Searching for collision states on an assembly.
- Study Objective:
-
The aim of the course Modeling and Simulation is to show the process of the design of the motion axis from the structural point of view.
- Study materials:
-
Materials of lectures and exercises in the form of PowerPoint presentations.
Catalogs of component manufacturers
- Note:
- Further information:
- No time-table has been prepared for this course
- The course is a part of the following study plans:
-
- 04 26 31 38 BSTR KPP 2012 P základ (compulsory course in the program)
- 08 40 45 52 BSTR KPP 2012 K základ (compulsory course in the program)
- 08 40 45 52 DSTR KPP 2012 K základ (compulsory course in the program)