CAD 2
Code | Completion | Credits | Range | Language |
---|---|---|---|---|
E136032 | Z | 2 | 0P+2C | English |
- Garant předmětu:
- Lecturer:
- Tutor:
- Supervisor:
- Department of Designing and Machine Components
- Synopsis:
-
Course follows Course Autodesk Inventor I. It is focused on usage of advanced and specialised tools in CAD Inventor. Students may use taught skills in courses like ED II, III and IV
- Requirements:
-
Knowledge of Autodesk Inventor I
- Syllabus of lectures:
-
Parametric modeling, Adaptive modeling (components), Creation of assembly, Generation of part list, Designing of shaft, Drive constraint, The parameters used for many components, Intelligent assembly with using skeleton, Derived assembly, Creation of gear drive and belt drive (+ control), Designing of frame, Creation of weldments
- Syllabus of tutorials:
-
1) Welded Assemblies
2) Sheet metal parts
3) Introduction into parameters in AI, derived parts
4) Advanced Techniques of parametric modelling
5) i-mates, i-parts, i-assemblies
6) Design Accelerator
7) Exploded Assemblies - Presentation
8) Free modelling, Plastic components
9) Inventor Studio
10) Assessment
- Study Objective:
-
Improving skills in Autodesk Inventor. Introduction into specialised tools in Inventor.
- Study materials:
-
AUTODESK, Inc.: Autodesk Inventor 2008, San Rafael, California, 2008
BANACH, D; JONES, T; KALAMEJA, A: Autodesk Inventor 2009 Essentials Plus, Autodesk Press
JONES, T; KALAMEJA, A: Autodesk Inventor 2009 Essentials Plus, Autodesk Press
- Note:
- Further information:
- No time-table has been prepared for this course
- The course is a part of the following study plans: