Engineering Design II

Garant předmětu:

Lecturer:

Tutor:

Supervisor:

Department of Designing and Machine Components

Synopsis:

Theoretical fundamentals of GPS (Geometrical Product Specification). Students will get critical knowledge about ISO system of limits and fits, tolerancing, surface texture, geometrical tolerance, dimensional loops, tolerancing of angles and cones, tolerancing of threads. Integral part of course is a project where students apply and practice their knowledge from lectures.

Requirements:

Basic rules of representation and dimensions of parts. (Engineering Design I)

Syllabus of lectures:

Tolerancing of longitudinal dimension

ISO system of limits and fits (Interchangeable system)

Tolerancing of surface texture

Geometrical tolerance

Dimensional loops

Tolerancing of angles and cones

Tolerancing of thread

Gradation of quantities - series of preferred numbers

Syllabus of tutorials:

Representation and dimension of gears and splines

Joint of a hub and a shift

Design of spindle shaft

Calculation of dimension loop

Study Objective:

Understanding of basic principles of design procedures and tolerancing.

Study materials:

Křivý, J., Pospíchal, J.: Fundamentals of design I, English texts

Křivý, J. : Fundamentals of design II - Rules of Interchangeability, English texts

Rolling bearings. SKF Main Catalogue. PUB BU/P1 10000/2 EN. August 2013 (EN)

Note:

Further information:

No time-table has been prepared for this course

The course is a part of the following study plans:

• 12 74 79 00 BTZSI 2012 A - prezenční anglicky (compulsory course in the program)
• 09 54 59 00 BSTR 2012 A - prezenční anglicky (compulsory course in the program)
• 09 54 59 00 DSTR 2012 A - prezenční anglicky (compulsory course in the program)