CZECH TECHNICAL UNIVERSITY IN PRAGUE
STUDY PLANS
2023/2024

# Optimization of Cutting Conditions

The course is not on the list Without time-table
Code Completion Credits Range
W34O004 ZK 60B
Garant předmětu:
Lecturer:
Tutor:
Supervisor:
Department of Machining, Process Planning and Metrology
Synopsis:

Economy of machining, machining costs. Importance of the optimisation of machining (cutting) processes. Trends in the development of cutting tools. Cutting tools optimisation. Variants in the optimisation of cutting conditions and tools life, single path optimisation, more complicated optimisations. Criteria for optimisations, restrictive conditions and their mathematical formulations. Possible solution regions. Step by step procedure for the optimisation of machining processes. Complex optimisation procedures. Optimum tool life. Optimisation SW. Stochastics of machining processes. Optimisation data. Optimisation with monitoring and adaptive control of machining processes.

Requirements:

Problem knowledge.

Syllabus of lectures:

1.Economy of machining, machining costs. Importance of the optimisation of machining (cutting) processes. The use of computers.

2.Trends in the development of cutting tools. Cutting tools optimisation.

3.Variants in the optimisation of cutting conditions and tools life, single path optimisation.

4.More complicated optimisations.

5.Criteria for optimisations and their mathematical formulations - criterion of minimum machining costs.

6.Criteria for optimisations and their mathematical formulations - criterion of maximum productivity and maximum material reduction.

7.Restrictive conditions and their mathematical formulations.

8.Restrictive conditions and their mathematical formulations - continuation.

9.Possible solution regions.

10.Optimum tool life. Step by step procedure for the optimisation of machining processes.

11.Complex optimisation procedures.

12.Optimisation data. Optimisation SW.

13.Stochastics of machining processes.

14.Optimisation with monitoring and adaptive control of machining processes.

Syllabus of tutorials:

1.Calculation of cutting power and number of revolutions in high speed cutting with advanced cutting tools.

2.Restrictive conditions formulations.

3.Optimum cutting conditions calculation in variants.

4.Optimum cutting conditions calculation in variants.

5.Machining costs calculation.

6.Algorithmisations of optimisation procedures.

Study Objective:
Study materials:

Chlds, T.H.C., Metal Machining,Arnold, GB, 2000

Note:
Further information:
No time-table has been prepared for this course
The course is a part of the following study plans:
Data valid to 2023-08-30
Aktualizace výše uvedených informací naleznete na adrese https://bilakniha.cvut.cz/en/predmet10895402.html