Logo ČVUT
CZECH TECHNICAL UNIVERSITY IN PRAGUE
STUDY PLANS
2024/2025

Experimental Methods in Machining

The course is not on the list Without time-table
Code Completion Credits Range
W34O002 ZK 60B
Garant předmětu:
Lecturer:
Tutor:
Supervisor:
Department of Machining, Process Planning and Metrology
Synopsis:

Principles of planning, realization and evaluation of experiments.

Experimental methods in machining: chip formation, primary and secondary plastic deformation, deformation of machined surface, residual stresses, work hardening, cutting forces, vibrations, heat and temperature, tool wear, tool life, machinability, cutting ability, cutting fluids.

Requirements:

Problem knowledge.

Syllabus of lectures:

Experimental studies of measuring forming strains

Optimization of boundaries for sheet and bulk forming

Measuring of forces, position, velocity, acceleration

Temperature measurement, thermocouples

Planning, realization and evaluation of experiments in machining

Chip formation, primary and secondary plastic deformation study

Deformation of machined surface, residual stresses and work hardening study

Machinability and cutting ability study, cutting fluids testing

Syllabus of tutorials:

Measuring of forces, position, velocity, acceleration

Temperature measurement, thermocouples

Planning, realization and evaluation of experiments in machining

Chip formation, primary and secondary plastic deformation study

Deformation of machined surface, residual stresses and work hardening study

Forces of cutting and vibrations study

Heat and temperature study

Tool wear and tool life study

Machinability and cutting ability study, cutting fluids testing

Study Objective:
Study materials:

Chlds, T.H.C., Metal Machining,Arnold, GB, 2000

Note:
Further information:
No time-table has been prepared for this course
The course is a part of the following study plans:
Data valid to 2024-06-13
Aktualizace výše uvedených informací naleznete na adrese https://bilakniha.cvut.cz/en/predmet10895202.html