Construction of Electronic Circuits

Lecturer:

Tutor:

Supervisor:

Department of Electrotechnology

Synopsis:

Principles of construction design and technological process of the electronic circuits realisation. Effect of construction design upon reliability of an equipment, electromagnetic and thermal interference. Technique and practical realisation of printed circuit board design, computer support. Technique and practical realisation of devices mounting. Testing and debugging of realised circuits. Course with project.

Requirements:

The credit reguirements: seminar presentation, realization of electronic circuit, protokol of circuit realization and the student must obtain minimally 50 % of avaliable points in the tests.

Syllabus of lectures:

1.Levels of designing works on electronic circuit

2.Realization methods of electronic circuits

3.Electronic circuits components

4.Passive components - specific properties

5.Active components - specific properties

6.Design technique of real circuits

7.Printed circuits board technologies and component bonding

8.Practical design of printed circuits boards

9.Component assembly. Soldering technique

10.Power supplies for electronic circuits, design, realization

11.Switching and wiring components

12.Putting into operation, testing

13.Selection of measuring methods and apparatus

14.Design effect on equipment reliability

Syllabus of tutorials:

1.Introduction. Safety provisions.

2.Catalogue of components. Setting of the project.

3.Methods of electronic circuits realization

4.Simple methods of realization

5.Design of printed circuits boards

6.Computer - aided program FORMICA

7.Electronic circuits realization - schematic diagram

8.Electronic circuits realization - function verification

9.Electronic circuits realization - printed circuits board

10.Electronic circuits realization - devices bonding

11.Electronic circuits realization - soldering

12.Circuits function testing

13.Measuring of circuit's parameters. Final report

14.A credit

Study Objective:

A student are well-educated of properties of fundamental electronic devices, theit application at realization of electronic circuits, technology of ralization of PCB and methods of actuating of electronic equipment

Study materials:

[1] Leonida, G., Handbook of Printed Circuit Design, Manufacture Components

& Assembly. Electrochemical Publications, IOM, 2000

Note:

Further information:

No time-table has been prepared for this course

The course is a part of the following study plans:

• Common plan- structured studies (elective specialized course)
• Computer Technology- structured studies (elective specialized course)
• Electronics and Communication Technology - structured studies (elective specialized course)
• Cybernetics and Measurements- structured studies (elective specialized course)
• Heavy-current Engineering- structured studies (elective specialized course)