Power Supply Design
Code | Completion | Credits | Range | Language |
---|---|---|---|---|
XD34NNZ | Z,ZK | 3 | 14+2s | Czech |
- Lecturer:
- Alexandr Krejčiřík (gar.)
- Tutor:
- Alexandr Krejčiřík (gar.)
- Supervisor:
- Department of Microelectronics
- Synopsis:
-
The Subject extends the subject Power Supply in Electronics and treats the integrated switching power supply configurations. The subject is meant for diploma project students designing the switching power supplies. It treats the switching power supply design programs and switching regulators component using PC A special attention is devoted to EMC requirements in switch-mode power supplies as well as to the cost versus operational efficiency ratio. Design of a switch-mode power supply.
- Requirements:
- Syllabus of lectures:
-
1. Switcher CAD - a program for switch-mode regulator design.
2. Increasing of output currents and voltages of integrated switch-mode power supplies.
3. MicroPower Switcher CAD - a program for small power Integrated switch-mode regulator design.
4. Design of the switch-mode regulator with low voltage power supply.
5. Switch-mode regulators with TOP switch circuits.
6. AC/DC-TOP - Calculation of the AC/DC sources with the TOP switch circuits.
7. PI Expert - a program for the switch-mode regulator design using TOP switch circuits.
8. Magnetic - Design Tool - a program for the magnetic circuit design for the switch-mode regulators.
9. Design of coils and transformers for switch-mode regulators.
10. Inductorless switch-mode regulator design, charge pumps.
11. Active harmonic filters for switch-mode regulators.
12. DC/DC converter design using switch-mode regulators.
13. Design of switch-mode regulator for a PC.
14. Choice of the passive components for the switch-mode regulator design.
- Syllabus of tutorials:
-
1. Methods of switch-mode power supplies measurement
2. Design of a switch-mode power supply increasing positive voltage using the SW CAD program
3. Design of the projected switch-mode power supply and measurement of its properties
4. Design of a positive voltage reducing switch-mode power supply using the SW CAD program
5. Design of the projected switch-mode power supply and measurement of its properties
6. Positive voltage inverting switch-mode power supply design using the SW CAD program
7. Design of the projected switch-mode power supply and measurement of its parameters
8. Design of a negative voltage increasing switch-mode power supply using the SW CAD program
9. Design of the projected power supply and measurement of its properties
10. Design of a negative voltage reducing switch-mode power supply using the SW CAD program
11. Design of the projected switch-mode power supply and measurement of its parameters
12. Design of a inverting negative voltage switch-mode power supply using the SW CAD program
13. Design of the projected switch-mode power supply proposed and measurement of its parameters
14. Design of current and voltage boosters for switch-mode power supplies.
- Study Objective:
- Study materials:
-
1. LINEAR TECHNOLOGY: Switcher Cad Users Manual. Linear Technology Corporation, Milpitas, CA 1992
- Note:
- Time-table for winter semester 2011/2012:
- Time-table is not available yet
- Time-table for summer semester 2011/2012:
- Time-table is not available yet
- The course is a part of the following study plans:
-
- Electronics - Electronic Systems- structured studies (compulsory elective course)
- Economics and Management in Electrical Engineering- structured studies (compulsory elective course)
- Electronics - Electronics and Photonics- structured studies (compulsory elective course)