Microprocessor Control of Power Converters
Code | Completion | Credits | Range | Language |
---|---|---|---|---|
X14MRM | Z,ZK | 4 | 2+2s | Czech |
- Lecturer:
- Tutor:
- Supervisor:
- Department of Electric Drives and Traction
- Synopsis:
-
The course perfects based knowledges about the control of electric drives. For design of modern electric drive controller it is necessary to manage the system per unit system, normalized quantities and basic control architectures. Students work with controllers based on modern microprocessors and digital signal processors. There is possible to get requainter with top end products in drive technology area.
- Requirements:
-
Participation on labs, solution of tasks.
- Syllabus of lectures:
-
1. Modern controlled drives structure, per unit system, normalized quantities
2. Support means for microprocessor controller development
3. Program realisation of the basic algorithm microprocessor controllers
4. Modulation program solution of a converter for asynchronous machine supply (AM)
5. System equations of an AM as ground of modern control methods
6. Scalar control of an AM drive
7. Structure of an AM drive with vector control
8. Controller for an AM direct torque control method for a GTO converter
9. AM direct torque control method for a transistor converter
10. Microprocessor controller of an excitation system for a synchronous machine
11. Control of a compatible rectifier with sinusoidal current taking-in from supply network
12. Circumferential solution of microprocessor controllers, digital signal processors
13. Drive testing, protections
14. Development trends in electric drives (fuzzy logic)
- Syllabus of tutorials:
-
1. Safety rules for the laboratory, control of test drives
2. Working with support program means
3. Per unit system and normalized quantities in microprocessor controllers
4. Assignment of the 1. individual task
5. Setup of the industry produced converter
6. Measuring on a modulator
7. Assignment of the 2. individual task
8. Setup of the industry produced converter
9. Measuring on the drive with vector control
10. Assignment of the 3. individual task
11. Measuring on the drive with direct torque control
12. Measuring on the compatible rectifier
13. Solution of the individual tasks
14. Check of individual tasks. Credit
- Study Objective:
- Study materials:
-
1.Forsythe,W.: Digital Control Mc Graw Hill, New York, 1991
2.Next literature will be specified by the lecturer
- Note:
- Further information:
- No time-table has been prepared for this course
- The course is a part of the following study plans:
-
- Electronics - Electronic Systems- structured studies (compulsory elective course)
- Electronics - Electronic Applications- structured studies (compulsory elective course)
- Electronics - Electronics and Photonics- structured studies (compulsory elective course)