Design and Development of Radio Devices

Lecturer:

Tutor:

Supervisor:

Department of Radioelectronics

Synopsis:

The course is for student, which want practically designed digital circuits usually using in communications systems. Design is concentrate on application of programmable digital circuits and signal processors. Within the course suppose the knowledge of the digital technique fundamentals.

Requirements:

Syllabus of lectures:

1. Introduction to the design of the radioelectronic devices

2. Analog component in digital systems, properties a their models

3. Digital circuits, processors, signal processors, transputer

4. Technologist aspects of the design of the radioelectronic devices, standards

5. Design and constructions of digital subsystems - methodics, computer support

6. Circuit for the A/D boundary, design analog inputs and outputs

7. Circuits for the frequency conversion, digital modulators and demodulators

8. Design and realisation of the gener. of sine waves , analog, digital and hybrid

9. Realisation of the digital filters in modern communications receivers

10. Realisation of the digital modulators and demodulators PCM, FSK a PSK

11. Connection in the digital systems, buses and communication between processors

12. Design of the digital circuit, hazard and metastable char. of digital circuits

13. Design digital systems up the 50MHz

14. Diagnostics of the digital devices, JTAG properties and using

Syllabus of tutorials:

1. Introduction

2. Design a realisation of the driver by synchronic circuit

3. Design of the arbitration circuit for global memory of the two signal processors

4. Realisation arbiter by programmable circuit

5. Realisation arbiter with the state diagrams

6. Design of the code generator and realisation by the programmable circuit isPL

7. Design of the encoder and decoder error-correction code

8. Analysis of the linear oscillator, encoders and decoders with the cyclic codes

9. Design of mP system, connection of the peripheries, multiplexing of the memories

10. Models of the reliability designed ?P system, comput. of the time without distiller

11. Conversion A/D, sigma ?, characteristic and noise

12. Measurement of the metastable characteristic of the logic circuits

13. Realisations DDS

14. Simulation of the digital circuit with respect to EMC

Study Objective:

Study materials:

[1] Digital Design Seminar, Texas Instruments, 1998

[2] High Speed Design Techniques, Analog Device, 1996

[3] Johnson, H.W., Graham, M.: High-speed digital design. Prentice Hall, 1993

Note:

Further information:

No time-table has been prepared for this course

The course is a part of the following study plans:

• Radioelektronika-inženýrský blok (compulsory elective course)
• Radioelektronika-inženýrský blok (compulsory elective course)