Logo ČVUT
Loading...
CZECH TECHNICAL UNIVERSITY IN PRAGUE
STUDY PLANS
2011/2012

Power Supply Design

The course is not on the list Without time-table
Code Completion Credits Range Language
34NNZ Z,ZK 4 2+2s Czech
The course is a substitute for:
Power Supply Design (X34NNZ)
Lecturer:
Tutor:
Supervisor:
Department of Microelectronics
Synopsis:

The Subject extends the subject Power Supply in Electronics and treats the

integrated switching power supply configurations. The subject is meant for

diploma project students designing the switching power supplies. It treats

the switching power supply design programs and switching regulators

component using PC A special attention is devoted to EMC requirements in

switch-mode power supplies as well as to the cost versus operational

efficiency ratio. Design of a switch-mode power supply.

Requirements:
Syllabus of lectures:

1. Switcher CAD - a program for switching regulator design

2. Increasing of the outp. currents and voltages of the integr. switch. power supplies

3. Integrated circuits for the switched multipliers and the dc voltage invertors

4. Design of the coils and transformers of the switching power supplies

5. Magnetic-Design-Tool- a program for magnetic circuit design

6. Active harmonic filters of the switching power supplies, preregulators

7. Filter CAD - a program for switching power supply filters design

8. Resonance switching power supplies, synchronous rectifiers

9. Integrated circuits for the battery feed switching power supplies

10. MicroPower Switcher CAD - a program for switching power supplies design

11. Integr. circuits for the switch.power supplies of the automatic battery chargers

12. Integrated circuits of the switching power supplies for light source control

13. Isolating feedback circuits in switching power supplies

14. NTC-R/T - a program for calcul. of thermistor resistance temper. dependence

Syllabus of tutorials:

1. Methods of switching power supplies measurement

2. Design of a switch.pow.supply increasing posit. voltage using SWCAD program

3. Design of the switching power supply proposed and measurement of its properties

4. Design of a switch.power supply reduc. positive voltage using SWCAD program

5. Design of the switching power supply proposed and measurement of its properties

6. Switching power supply design inverting positive voltage using SWCAD program

7. Design of the switch. power supply proposed and measurement of its parameters

8. Design of a switch.power supply increas. negative voltage using SWCAD program

9. Design of the switching power supply proposed and measurement of its properties

10. Design of a switch.power supply reduc. negative voltage using SWCAD program

11. Design of the switch. power supply proposed and measurement of its parameters

12. Design of a switch.power supply invert. negative voltage using SWCAD program

13. Design of the switch. power supply proposed and measurement of its parameters

14. Design of the current and voltage boosters for switching power supplies

Study Objective:
Study materials:

[1] MOTOROLA: Linear/Switchmode Voltage Regulator Handbook. Motorola Literature Center, Phoenix 1989

[3] LINEAR TECHNOLOGY: Switcher Cad Users Manual. Linear Technology Corporation, Milpitas, CA 1992

Note:
Further information:
No time-table has been prepared for this course
The course is a part of the following study plans:
Generated on 2012-7-9
For updated information see http://bilakniha.cvut.cz/en/predmet11007104.html