Logo ČVUT
Loading...
CZECH TECHNICAL UNIVERSITY IN PRAGUE
STUDY PLANS
2011/2012

Electronic Systems

The course is not on the list Without time-table
Code Completion Credits Range
31ES Z,ZK 4 2+2s
Lecturer:
Tutor:
Supervisor:
Department of Circuit Theory
Synopsis:

The aim of subject is to develop student's knowledge of analog electronic circuits. Attention is devoted to the new ways of analog circuit design, current-mode circuits, current-feedback amplifiers, prospective linear and non-linear high- speed building blocks and converters. Modelling and simulation of such blocks is discussed. Modern methods of signal generation and PLL systems design and exploation are presented.

Requirements:
Syllabus of lectures:

1. Classification of functional blocks, methods of analysis and simulation

2. Voltage- and current-feedback circuits and systems. A comparison

3. Current-mode electronic circuits. Translinear principle

4. Conventional and special amplifiers. Parameters, modelling

5. Analog multipliers, controlled amplifiers, rectifiers, conveyors

6. Electronic gain-control of analog systems

7. Switched-capacitor and switched-current circuits - a survey

8. Signal generation, oscillators, controlled oscillators (VCO)

9. PLL: basic principle, building blocks, design, modelling

10. PLL application, frequency synthesis, frequency modulation and demodulation

11. Impulse modulation

12. D/A converters based on current- and charge-weighting. Sampling circuits

13. A/D converters (parallel, step by step, pipeline, approximation, following, integrating, sigma-delta)

14. Co-operation of analog and digital systems - conditions, constraints

Syllabus of tutorials:

1. A macromodelling of analog and analog-to-digital building blocks

2. Building block parameters determination with respect to a simulation result

3. High-speed feedback nets containing operational and transimpedance amplifiers

4. Non-linear building blocks

5. Parameter identification for macromodels of analog building blocks

6. Voltage- and current-controlled amplifiers. AGC subsystems

7. Non-linear feedback nets - design, verification

8. Voltage- and current-controlled generators - design, measurement

9. PLL - design using special ICs

10. Measurement of PLL subsystem

11. Impulse modulators and demodulators

12. Analog-to-digital subsystems (multipliers, comverters)

13. Semestral work presentation

14. Semestral work presentation

Study Objective:
Study materials:

1. Toumazou, C., Lidgey, F.J., Haigh, D.G.: Analog IC Design: the Current-Mode Approach. Peter Peregrinus, 1993

2. Tuinenga, P.W.: SPICE: A Guide to Circuit Simulation and Analysis. Prentice Hall, 1992

Note:
Further information:
No time-table has been prepared for this course
The course is a part of the following study plans:
Generated on 2012-7-9
For updated information see http://bilakniha.cvut.cz/en/predmet10999404.html