Machine Elements and Systems

Lecturer:

Tutor:

Synopsis:

Compulsory course for specialization Electric Machines and Technological Systems. The base operation properties of hydraulic machines, compressors and ventilators. Optimalisation of operation conditions of machines. Regulation of mechanical systems. Influence of regulation on working poin systems. Check calculation of base mechanical parts.

Requirements:

Syllabus of lectures:

1. Energy consumption of working machine systems

2. Dynamic characteristic of working machine systems for transport of liquits

3. Dynamic characteristic of working machine systems for transport of gases

4. Dynamic characteristic of working machine systems for mechanics transport

5. Regulary possibility, working optimization of machine systems

6. Influence of working operational on working point and energy consumption

7. Method proposal and control standardized machine elements

8. Fundamental proceeding control of machine elements

9. Selection, application and controls of standardized machine elements

10. Problems reliability machine elements and systems

11. Shaft support, transmission line, shaft control, critical shaft speed

12. Plain bearing, antifriction bearing,, the coupling

13. The gears, the gearboxs, control calculation

14. Sort of weld, control calculation

Syllabus of tutorials:

1. Quantitative and qualitative cost of energy consumption of fundamental machines

2. Calculation of characteristic pipe system

3. Calculation of working point of hydraulic pump

4. Calculation of energy saving at regulary hydraulic pump

5. Calculation of characteristic pipe system for transport of gases. Control testamur

6. Laboratory measuring of characteristic pump

7. Calculation of energy saving at regulary ventilators

8. Calculation of working optimization of machine systems

9. Laboratory measuring of characteristic ventilators with support of PC

10. Control calculation standardized machine elements

11. Control calculation of critical shaft speed, shaft control

12. Proposal and control calculation of bering

13. Proposal and control calculation of involute gearing

14. Proposal and control calculation of welds

Study Objective:

Study materials:

[1] 4. Mareš, R., Šifner, O., Kadrnožka,J. : Tables of Properties of Water and Steam. VUITIUM Brno, 1999

[2]. Anderson, J.D. : Modern Compressible Flow. Mc Graw-Hill Book Company, New York, 1982.

Note:

Further information:

No time-table has been prepared for this course

The course is a part of the following study plans:

• Biomedicínské inženýrství - inženýrský blok (elective specialized course)
• Biomedicínské inženýrství - inženýrský blok (elective specialized course)