Logo ČVUT
CZECH TECHNICAL UNIVERSITY IN PRAGUE
STUDY PLANS
2019/2020

Microwave Measurements

The course is not on the list Without time-table
Code Completion Credits Range Language
B2M17MIMA Z,ZK 6 2P+2L Czech
Lecturer:
Tutor:
Supervisor:
Department of Electromagnetic Field
Synopsis:

Fast development of wireless radio data communications (both mobile and stationary) also results in requirements for measurement of numerous related electrical parameters in frequency band ranging from hundreds of MHz to tens of GHz. The „Microwave measurements“ subject brings description of all important measurement instruments and measurement methods used in this field. Instructions devoted to measurement devices also cover detailed inner structures, principles of operation, common measurement setups and optimum setting. Even relatively complex measurement instruments and setups are discussed, for example those used for measurement of noise and non-linear parameters. Exercises are focused on practical measurements commonly performed in the wireless communication field. Besides modern measurement instruments, students also learn a number of typical RF and microwave components, circuits, subsystems and digitally modulated signals.

Requirements:
Syllabus of lectures:

1. Measured parameters, measurement errors, impedance mismatch influences

2. Measurement setup components - interconnecting lines, adapters, matched loads, attenuators

3. Measurement setup components - power dividers, couplers, detectors, directional bridges

4. Microwave generators and synthesizers

5. Measurement of frequency

6. Power measurement

7. Scalar analyzers

8. Vector network analyzers

9. Vector calibration, measurement of s-parameters

10. Spectrum analyzers

11. Measurement of non-linear parameters

12. Measurement of noise parameters

13. Vector signal analyzer, measurement of modulated signals

14. Microwave oscilloscopes, time-domain measurements

Syllabus of tutorials:

1. Introduction to laboratory works

2. Scalar analyzer - measurement of MMICs

3. Scalar analyzer - measurement of waveguide components

4. Vector network analyzer - measurement of s-parameters

5. Vector network analyzer - measurement of IQ-modulator

6. Vector network analyzer - measurement of resonators

7. Non-linear parameter measurements - measurement of generators, amplifiers

8. Non-linear parameter measurements - measurement of frequency multipliers, mixers, limiters

9. Measurement of noise figure - amplifiers, passive components

10. Microwave oscilloscopes - measurement of eye-diagrams

11. Vector signal analyzer - EVM measurements

12. Comprehensive measurement of microwave front-end

13. Comprehensive measurement of microwave front-end

14. Checking of measurement reports

Study Objective:
Study materials:

Hoffmann K., Hudec P.: Vysokofrekvenční a mikrovlnná měření, skriptum ČVUT 2009.

Teppati V., Ferrero A., Sayed M.: Modern RF and Microwave Measurement Techniques, Cambridge University Press 2013.

Scott A. W., Frobenius R.: RF Measurements for Cellular Phones and Wireless Data Systems, John Wiley and Sons 2008.

McCune E.: Practical Digital Wireless Signals, Cambridge University Press 2010.

Additional study materials including lecture Power-Point presentations and laboratory work instructions will be available at Moodle.

Note:
Further information:
http://moodle.fel.cvut.cz
No time-table has been prepared for this course
The course is a part of the following study plans:
Data valid to 2019-10-14
For updated information see http://bilakniha.cvut.cz/en/predmet5597706.html