Logo ČVUT
CZECH TECHNICAL UNIVERSITY IN PRAGUE
STUDY PLANS
2023/2024

Embedded Systems

The course is not on the list Without time-table
Code Completion Credits Range Language
2141074 Z,ZK 4 1P+0C+2L Czech
Garant předmětu:
Lecturer:
Tutor:
Supervisor:
Department of Instrumentation and Control Engineering
Synopsis:
Requirements:
Syllabus of lectures:

1.^Introduction into microcomputer programming - basic concepts, registers, memories

2.^Binary arithmetic, numbers representation

3.^Assembler 8051

4.^Assembler 8051

5.^Microcomputer memories

6.^Processor I51, internal architecture

7.^Interrupt system

8.^Busses, auxiliary circuits

9.^I/O circuits for digital interfaces

10.^D/A, A/D converters, unified signal

11.^Counters/timers, watch dog

12.^Serial and parallel interfaces, buses for data transfer

13^Transfer channel, modems

14.^Design of simple microcomputer system.

Syllabus of tutorials:

1.^Basic data, numerical systems, data presentation, binary operations as addition, subtraction, multiplication, division

2.^Using Keil IDE for I51, 1st semester work setting

3.^1st semester work solving

4.^1st semester work solving

5.^1st semester work solving and its verification

6.^Development tool kit LabTech51

7.^Development tool kit BAST166 and programming in ANSY-C

8.^Development tool kit BAST166 and programming in ANSY-C, examples

9.^Intelligent servo drive AtlasCopco, basic features and programming, 2nd semester work setting

10.^2nd semester work solving

11.^2nd semester work solving

12.^2nd semester work solving

13.^2nd semester work solving

14.^2nd semester work verification, assesment

Study Objective:
Study materials:
Note:
Further information:
No time-table has been prepared for this course
The course is a part of the following study plans:
Data valid to 2024-03-16
Aktualizace výše uvedených informací naleznete na adrese https://bilakniha.cvut.cz/en/predmet3053906.html