Computer Control of Experiment

Course guarantor:

Miroslav Čech

Lecturer:

Miroslav Čech

Tutor:

Supervisor:

Department of Laser Physics and Photonics

Synopsis:

Introduction, sensors, fundamentals of electronics and digital technology, D/A and A/D converters, fundamentals of data communications, RS232C, TTY, RS485, IEEE488 interfaces, software, LabView

Requirements:

The course concludes with an oral exam on the topics covered.

Syllabus of lectures:

1. Block diagram of control and measuring systems, Sensors

2. Requirements for sensors, passive and active sensors, principles

3. Interference on the measuring line. Signal conditioning circuits

4. Fundamentals of electronics. Filters, operational amplifier, integrator, differentiator, feedback

5. Fundamentals of digital technology, number systems, representation of numbers and characters

6. D/A and A/D converters, sampling theorem, aliasing

7. Fundamentals of data communications, serial and parallel transmission, security codes

8. Computer interfaces, serial, parallel, TTY, RS485, USB

9. IEEE-488 interface, SCPI standard

10. Computer software, graphical development systems, LabView

11. Practical examples of programs in the LabView system

12. Practical task

Syllabus of tutorials:

Study Objective:

Knowledge: Structure and principles of computer control of experiments

Skills: to design a realize measurement and control system.

Study materials:

Key references:

1.H. Häberle: Industrial Electronics and Information Technology, Europa-Sobotáles cz., Praha 2003 (in Czech)

2.J. Balátě a kol.: Technical Resources of Automatic Control, SNTL Praha, 1986 (in Czech)

3.F. Dlabola, J. Starý: Microprocessor Systems a data transfer, NDS Praha 1986 (in Czech)

4.J. Bayer, J. Bílek: Control Systems Design, Skripta ČVUT, 1987 (in Czech)

5.V. Haasz, J. Roztočil, J. Novák: Digital Measurement Systems, Skripta ČVUT, 2000 (in Czech)

6.M. Šnorek: Standard Interfaces of PC, Grada, Praha 1992 (in Czech)

7.J. Pavel, J. Resl: Electrotechnic I, Vydavatelství ČVUT, Praha 1997 (in Czech)

8.J. Pavel, J. Resl: Electrotechnic II, Vydavatelství ČVUT, Praha 1998 (in Czech)

9.B. Kainka: USB - Measurement, Control and Regulation by the USB, Ben, Praha 2002 (in Czech)

10.J. Peterka: Computer Network 3.0., www.earchiv.cz, 2004 (in Czech)

Recommended references:

1.1. IEEE Std. 481.1-2003 , IEEE Standard for Higher Performance Protocol for Standard Digital Interface for Programmable Instrumentation, IEEE New York, 2003

2.W. Kester: Analog-Digital Conversion, Analog Devices, 2004

Note:

Time-table for winter semester 2025/2026:

Time-table is not available yet

Time-table for summer semester 2025/2026:

Time-table is not available yet

The course is a part of the following study plans: