Logo ČVUT
CZECH TECHNICAL UNIVERSITY IN PRAGUE
STUDY PLANS
2019/2020

Autodesk for 3D Design in Engineering

The course is not on the list Without time-table
Code Completion Credits Range Language
2336005 Z 3 0P+2C Czech
Lecturer:
Tutor:
Supervisor:
Department of Manufacturing Technology
Synopsis:

The course focuses on the spatial (3D) modeling for Technological structures. The object is to blend design and technology. The course will be taught through practical exercises focused on the issues of digital design with the immediate exercise examples. The use of Autodesk products and other design and construction of mechanical parts and assemblies, stress analysis of parts, assemblies and trusses. Using software to create renderings, animations and assembly diagrams. This course should provide a context and conditions of graduates of the Faculty of Mechanical Engineering for their future careers, where they are primarily in technology and engineering professions demands on knowledge of 3D modeling.

Requirements:
Syllabus of lectures:

The content of exercises:

The 1st Environment and work with the project.

The 2nd Working with sketches, bonds.

The 3rd Proposal is part of the environment components.

04th The proposal included in the assembly environment.

05th Assembly Modeling I.

06th Assembly Modeling II, documentation management.

07th Design of standardized parts and assemblies

08th Construction of metal parts.

09th Lattice structure.

10th Creation of manufacturing documentation.

11th Rendr and animation.

12th Strength and dynamic simulation reports

13th Stress analysis of trusses

Syllabus of tutorials:

The content of exercises:

The 1st Environment and work with the project.

The 2nd Working with sketches, bonds.

The 3rd Proposal is part of the environment components.

04th The proposal included in the assembly environment.

05th Assembly Modeling I.

06th Assembly Modeling II, documentation management.

07th Design of standardized parts and assemblies

08th Construction of metal parts.

09th Lattice structure.

10th Creation of manufacturing documentation.

11th Rendr and animation.

12th Strength and dynamic simulation reports

13th Stress analysis of trusses

Study Objective:
Study materials:
Note:
Further information:
No time-table has been prepared for this course
The course is a part of the following study plans:
Data valid to 2019-10-14
For updated information see http://bilakniha.cvut.cz/en/predmet1572506.html