Logo ČVUT
CZECH TECHNICAL UNIVERSITY IN PRAGUE
STUDY PLANS
2019/2020

Measurement on Process Equipment

The course is not on the list Without time-table
Code Completion Credits Range Language
E182702 KZ 3 0+3
Lecturer:
Tutor:
Supervisor:
Department of Process Engineering
Synopsis:

Measurement and evaluation of process characteristics, material and energy balances on selected process equipments in the pilot hall and laboratories of the Department.

Requirements:
Syllabus of lectures:

1. Introduction. Safety instructions

2. Rheology - rotary viscosimeter and injection viscosimeter

3. RTD

4. Mixing I - homogenization

5. Mixing II - suspendation

6. Fluidization (fixed bed, fluidized bed)

7. Laboratory fermenter (mass transfer)

8. Film evaporator

9. Convective dryer (drying curve)

10. Spray dryer

11. Ohmic heating I

12. Ohmic heating II

13. Presentation of experiment results

Syllabus of tutorials:

1. Introduction. Safety instructions

2. Rheology - rotary viscosimeter and injection viscosimeter

3. RTD

4. Mixing I - homogenization

5. Mixing II - suspendation

6. Fluidization (fixed bed, fluidized bed)

7. Laboratory fermenter (mass transfer)

8. Film evaporator

9. Convective dryer (drying curve)

10. Spray dryer

11. Ohmic heating I

12. Ohmic heating II

13. Presentation of experiment results

Study Objective:
Study materials:
Note:
Further information:
No time-table has been prepared for this course
The course is a part of the following study plans:
Data valid to 2019-09-18
For updated information see http://bilakniha.cvut.cz/en/predmet1357306.html