Logo ČVUT
CZECH TECHNICAL UNIVERSITY IN PRAGUE
STUDY PLANS
2019/2020

CAD 2

The course is not on the list Without time-table
Code Completion Credits Range Language
E136032 Z 2 0+2
Lecturer:
Tutor:
Supervisor:
Department of Designing and Machine Components
Synopsis:

Course follows Course Autodesk Inventor I. It is focused on usage of advanced and specialised tools in CAD Inventor. Students may use taught skills in courses like ED II, III and IV

Requirements:

Knowledge of Autodesk Inventor I

Syllabus of lectures:

Parametric modeling, Adaptive modeling (components), Creation of assembly, Generation of part list, Designing of shaft, Drive constraint, The parameters used for many components, Intelligent assembly with using skeleton, Derived assembly, Creation of gear drive and belt drive (+ control), Designing of frame, Creation of weldments

Syllabus of tutorials:

1) Welded Assemblies

2) Sheet metal parts

3) Introduction into parameters in AI, derived parts

4) Advanced Techniques of parametric modelling

5) i-mates, i-parts, i-assemblies

6) Design Accelerator

7) Exploded Assemblies - Presentation

8) Free modelling, Plastic components

9) Inventor Studio

10) Assessment

Study Objective:

Improving skills in Autodesk Inventor. Introduction into specialised tools in Inventor.

Study materials:

AUTODESK, Inc.: Autodesk Inventor 2008, San Rafael, California, 2008

BANACH, D; JONES, T; KALAMEJA, A: Autodesk Inventor 2009 Essentials Plus, Autodesk Press

JONES, T; KALAMEJA, A: Autodesk Inventor 2009 Essentials Plus, Autodesk Press

Note:
Further information:
No time-table has been prepared for this course
The course is a part of the following study plans:
Data valid to 2019-10-16
For updated information see http://bilakniha.cvut.cz/en/predmet1308006.html