Logo ČVUT
CZECH TECHNICAL UNIVERSITY IN PRAGUE
STUDY PLANS
2018/2019

Embedded Systems Application

The course is not on the list Without time-table
Code Completion Credits Range Language
AD4M38AVS Z,ZK 6 14P+6L Czech
Lecturer:
Tutor:
Supervisor:
Department of Measurement
Synopsis:

This course presents applications of embedded systems and their specifics. It is expected that the students have had a programming course, and thus the course is more oriented on explaining and describing the blocks and functions of embedded systems and their use in signal processing, rather than writing code.

After completing this course, students should have an overview of usability and power of available processors, and their peripherals, on the basis of which, they should be able to independently design embedded systems for a wide spectrum of applications.

Requirements:

Basic knowledge of C / C ++ programming language

Syllabus of lectures:

1. Microprocessor and microcontroller in an embedded system, requirements

2. Microprocessors and microcontrollers typically used in embedded systems

3. Application of 8-bit microcontrollers in a deep embedded system

4. Review microcontrollers with 32-bit architecture ARM7, ARM9, Cortex M3

5. Analog Inputs and outputs ( ADC, DAC, filtration, input protection)

6. DSP´s used in embedded systems, their specialised blocks and functions

7. Review basic methods of digital signal processing and their implementation in embedded system

8. Input of a image signal to the embedded system (CMOS image sensor interfacing, DMA controller)

9. Design of embedded system with more microcontrollers, tasks partition

10 Design of a reliable and fault tolerant embedded system

11. Review of application of typical embedded systems

12. Use of embedded system in communication

13. Case study - embedded system design - consumer electronics (digital camera)

14. Case study - design of a data acquisition system

Syllabus of tutorials:

1. Configuring GPIO and timer on ARM STM32F2xx

2. Communication via UART interface

3. Use the rotary encoder to control the application, control the full graphic LCD and create your own library

4. Finishing the task from the past - graphical LCD control and creation of own library

5. Usage of A/D and D/A converter on ARM STM32F2xx processor

6. Control of dual-axis accelerometer

7. Using the ethernet interface for remote access

8. Implementation of DDS algorithm

9. Design and implementation of digital filters (FIR)

10. Individual project solution

11. Individual project solution

12. Individual project solution

13. Individual project solution

14.Submission of individual project, presentation of projects, evaluation, assesment

Study Objective:

The aim of the course is to provide students an overview of functional capabilities, performance and peripheral devices, input and output blocks, which will enable them to orientate in the choice of microprocessor and microcontroller in a given embedded system and its subsequent use and programming.

Study materials:

[1] Yiu J.: The Definitive Guide to ARM? Cortex -M3 and Cortex-M4 Processors, Newnes

[2] Balch, M.: COMPLETE DIGITAL DESIGN. A Comprehensive Guide to Digital Electronics and Computer System Architecture, McGRAW-HILL

Note:
Further information:
http://measure.feld.cvut.cz/vyuka/predmety/A4M38AVS
No time-table has been prepared for this course
The course is a part of the following study plans:
Data valid to 2019-08-20
For updated information see http://bilakniha.cvut.cz/en/predmet1211106.html