Autodesk for 3D Design in Engineering
| Code | Completion | Credits | Range | Language |
|---|---|---|---|---|
| 2336005 | Z | 3 | 0+2 | Czech |
- Lecturer:
- Michal Pakosta (gar.)
- Tutor:
- Michal Pakosta (gar.)
- Supervisor:
- Department of Manufacturing Technology
- Synopsis:
-
The course focuses on the spatial (3D) modeling for Technological structures. The object is to blend design and technology. The course will be taught through practical exercises focused on the issues of digital design with the immediate exercise examples. The use of Autodesk products and other design and construction of mechanical parts and assemblies, stress analysis of parts, assemblies and trusses. Using software to create renderings, animations and assembly diagrams. This course should provide a context and conditions of graduates of the Faculty of Mechanical Engineering for their future careers, where they are primarily in technology and engineering professions demands on knowledge of 3D modeling.
- Requirements:
- Syllabus of lectures:
-
The content of exercises:
The 1st Environment and work with the project.
The 2nd Working with sketches, bonds.
The 3rd Proposal is part of the environment components.
04th The proposal included in the assembly environment.
05th Assembly Modeling I.
06th Assembly Modeling II, documentation management.
07th Design of standardized parts and assemblies
08th Construction of metal parts.
09th Lattice structure.
10th Creation of manufacturing documentation.
11th Rendr and animation.
12th Strength and dynamic simulation reports
13th Stress analysis of trusses
- Syllabus of tutorials:
-
The content of exercises:
The 1st Environment and work with the project.
The 2nd Working with sketches, bonds.
The 3rd Proposal is part of the environment components.
04th The proposal included in the assembly environment.
05th Assembly Modeling I.
06th Assembly Modeling II, documentation management.
07th Design of standardized parts and assemblies
08th Construction of metal parts.
09th Lattice structure.
10th Creation of manufacturing documentation.
11th Rendr and animation.
12th Strength and dynamic simulation reports
13th Stress analysis of trusses
- Study Objective:
- Study materials:
- Note:
- Time-table for winter semester 2011/2012:
- Time-table is not available yet
- Time-table for summer semester 2011/2012:
- Time-table is not available yet
- The course is a part of the following study plans: