CAD 2

Lecturer:

Karel Petr (gar.), Jaroslav Pospíchal (gar.)

Tutor:

Karel Petr (gar.), Jaroslav Pospíchal (gar.)

Supervisor:

Department of Designing and Machine Components

Synopsis:

Computer Aided Design at the middle level. Link to subjects in the second basic studies at the Czech Technical University in Prague: Design III, Design IV, Project

Requirements:

Computer Aided Design at the middle level.

Syllabus of lectures:

Parametric modeling, Adaptive modeling (components), Creation of assembly, Generation of part list, Designing of shaft, Drive constraint, The parameters used for many components, Intelligent assembly with using skeleton, Derived assembly, Creation of gear drive and belt drive (+ control), Designing of frame, Creation of weldments

Syllabus of tutorials:

Same like Outline and Sylabus of Excercises

Study Objective:

Fundamentals of drawing in Autodesk Inventor.

Study materials:

AUTODESK, Inc.: Autodesk Inventor 2008, San Rafael, California, 2008

BANACH, D; JONES, T; KALAMEJA, A: Autodesk Inventor 2009 Essentials Plus, Autodesk Press

JONES, T; KALAMEJA, A: Autodesk Inventor 2009 Essentials Plus, Autodesk Press

Mastering Autodesk Inventor 2009 and Autodesk Inventor LT 2009 / Curtis Waguespack ... [et al.]. ? 1st ed. p. cm.ISBN 978-0-470-29314-0 (pbk. : website)

Note:

Time-table for winter semester 2011/2012:

Time-table is not available yet

Time-table for summer semester 2011/2012:

	06:00–08:0008:00–10:0010:00–12:0012:00–14:0014:00–16:0016:00–18:0018:00–20:0020:00–22:0022:00–24:00
Mon
Tue
Fri
Thu
Fri

The course is a part of the following study plans: